Product Description
If you're like us we never like to trailer our Spyders but sometimes you do need to and there are very few ways to do it without damaging something. For sure going through the wheels can cause scuff marks and wrapping around the a-arms can scuff the paint too and that's no good.
What we have on all of our Spyders is a stainless steel ring that replaces the the nut on the bottom shock bolt. You will have to lift the Spyder just enough to take pressure off the lower bolt so you can pull it out and turn it so the nut is facing the front. This gives you a very secure way to tie down the front of your Spyder without damaging your paint.
Torque is the same as before, either 30-35lbs or just good and tight.
These work on all Can Am Spyders from 2008+ GS/RS/RSS/ST/STS/STLTD/RT/RTS/RTLTD/RT - Sea to Sky / F3/F3S/F3T/F3LTD
This is another Lamonster® Approved product.
If you have any questions about this product email us at LamonsterGarageSales@gmail.com
WARNING: California Residents - www.p65warnings.ca.gov
