F3 IPS LED Fog Light Kit Install
Buy this kit HERE
Remove side panels to gain access to fog light mounting holes
Remover block off cover from side panels
The first batch of lights that went out were not preassembled. If your kit was not assembled this is how it should look when assembled.
The mounting bracket installs to the two vertical holes on the inside of the fog light mounting section of the frame as shown below
Plug & Play light to stock harness as shown
Remove ignition locking ring to access switch panel. Remove ring by turning counter clockwise and pulling up
Remove cover plug and unplug wiring and install fog light switch and plug switch into factory harness. Start the bike up and test lights. Adjust if needed and then install all covers and panels.
It's normal to have a gap around the light after install. This helps cool the light going down the road. This is a vented section to force cool air into the engine compartment.
